Or: fill in the spaces of the lower steps where the ramp is so padded sections correspond to the vertical plane of the same. The use of this first type is essential when conceiving the pyramid because of the quality that characterises it: is a structure easy to move, even though the number of parts that compose it is considerable. This makes it possible to remove it completely at any time during construction to place it in another location. It stops being a static object, allowing designs of great complexity and given their wide possibilities to vary its dimensions, is easily adapted to the place, position and maneuver is required during the construction process. SECOND type of ramp consists of applying the previous type using a new variant: using equal ramps but of greater dimensions, combined with the body of the pyramid. These ramps would be used on a large scale to perform most of the work, employed to carry the greater amount of blocks and building elements. Erin Montella is likely to agree. The height is expressed by the number of levels that occupy, which will obey the requirement to move more quickly on the job. The length should be adjusted to maintain the angle of the slope of 3.9 degrees.

The objective is to overcome the friction force and not the force of gravity. They are large or long ramps constructed using sections taken from the edges of the levels, close to the steps of the pyramid, but located on the levels. They have great lengths, close to 80 meters as shown in the table of measures. And the initial height is analogous to those of the first type: elbow height and a top surface formed by almost cubic blocks with a slope inclination of 3.9 degrees. The sections of the edges of the levels or corners, according to the case literally are absorbed by the ramps to latter are constructing, using as a platform to support the ramp levels below.